home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Chip 1996 September
/
CHIP 1996 szeptember (CD07).zip
/
CHIP_CD07.ISO
/
drivers
/
ati
/
64m31201
/
readme.txt
< prev
Wrap
Text File
|
1995-12-13
|
3KB
|
79 lines
mach64, 64M31201.ZIP
*****************************
1.0 Introduction
2.0 Installation Notes
3.0 Software MPEG Player requirements
*****************************
1.0 Introduction
The mach64 device drivers supplied here are for Windows 3.1 and
Windows 3.11. This ZIP file contains both the Windows 3.1X
display drivers and software MPEG player designed for the
mach64-based graphics accelerator products.
*****************************
2.0 Installation Notes
IF YOU HAVE NOT INSTALLED A mach64 WINDOWS DRIVER PREVIOUSLY, YOU MAY
REQUIRE YOUR MICROSOFT WINDOWS DISKETTES TO COMPLETE THE INSTALLATION
OF THIS DRIVER.
1. Ensure that you have a copy LOAD64.ZIP. It is available on the ATI
BBS, ftp site (ftp.atitech.ca), and on our CompuServe forum (GO
ATITECH).
2. Ensure that you have a copy of PKUNZIP.EXE, v1.10 or later.
PKUNZIP is available on most BBS and information services, including
the ATI BBS and CompuServe.
3. Do NOT attempt to perform the driver installation from within
Windows Exit Windows completely, and perform the following operations
in DOS.
4. Unzip LOAD64.ZIP and 64M31201.ZIP into the same temporary directory
on your hard disk, then run the LOAD64.EXE utility. For example:
MD \ATITEMP
PKUNZIP LOAD64.ZIP \ATITEMP
PKUNZIP 64M31201.ZIP \ATITEMP
CD \ATITEMP
LOAD64.EXE
5. Follow the screen prompts for installing the Windows3.1 driver.
IF YOU RECEIVE AN ERROR MESSAGE, INDICATING THAT A CERTAIN FONT (.fon)
FILE IS NOT PRESENT, YOU WILL NEED TO RUN WINDOWS SETUP FROM DOS TO
COMPLETE THE INSTALLATION. WINDOWS SETUP WILL PROMPT YOU FOR THE
DISKS ON WHICH THESE FONT FILES ARE FOUND.
6. Once the driver has been installed, you can delete the contents of
the temporary directory (DEL \ATITEMP\*.*) and delete the directory
itself (RD \ATITEMP).
7. We recommend that you keep a copy of the ZIP files (64M31201.ZIP
and LOAD64.ZIP), in case you need to install the driver again.
*****************************
3.0 Software MPEG Player requirements
While this application will run on most systems, ATI recommends a
minimum of a P5-75 with 8MB of RAM and PCI-bus for good quality
playback of MPEG videos.
This product requires a mach64 PCI or VLB graphics accelerator. ISA
cards and VLB cards with the aperture disabled are not recommended for
MPEG playback.
NOTE: Microsoft's Video for Windows 1.1E is required.
For more information regarding the ATI PLAYER see the file ATIPLAY.WRI
located in the ATI\ATIDESK sub-directory.
*****************************